Light and nanotechnology prevent bacterial infections on medical implants – Reducing Costs and Recurring Surgeries


Image of the surgical implants, covered with gold nanoparticles (pile of meshes on the left) compared to the original surgical meshes previous to the treatment (pile of meshes on the right). Credit: ICFO

Invented approximately 50 years ago, surgical medical meshes have become key elements in the recovery procedures of damaged-tissue surgeries, the most common being hernia repair.

When implanted within the tissue of the patient, the flexible and conformable design of these meshes hold muscles securely and allows quicker recovery than conventional surgical procedures of sewing and stitching.

However, the insertion of a medical implant in a patient’s body carries the risk of bacterial contamination during surgery and subsequent formation of an infectious biofilm over the surface of the surgical .

Such biofilms tend to act like a plastic coating, preventing any sort of antibiotic agent from reaching and attacking the formed on the film in order to stop the infection. Thus, antibiotic therapies, which are time-limited, could fail against super-resistant bacteria and the patient could end up in recurring or never-ending surgeries that could even lead to death.

In fact, according to the European Antimicrobial Resistance Surveillance Network (EARS-Net), in 2015, more than 30,000 deaths in Europe were linked to infections with antibiotic-resistant bacteria.

Physicians have used several approaches to prevent implant contamination during surgery. Post-surgery aseptic protocols have been established and implemented to fight these antibiotic-resistant bacteria, but none have entirely fulfilled the role of solving this issue.

SEM micrographs of the S. aureus biofilm formed on the surgical mesh surface. Credit: ICFO

In a recent study published in Nano Letters and highlighted in Nature Photonics, ICFO researchers Dr. Ignacio de Miguel, Arantxa Albornoz, led by ICREA Prof. at ICFO Romain Quidant, in collaboration with researchers Irene Prieto, Dr. Vanesa Sanz, Dr. Christine Weis and Dr. Pau Turon from the B. Braun and pharmaceutical device company, have devised a novel technique that uses nanotechnology and photonics to dramatically improve the performance of medical meshes for surgical implants.

In collaboration since 2012, the team of researchers at ICFO and B. Braun Surgical, S.A., developed a medical mesh with a particular feature: The surface of the mesh was chemically modified to anchor millions of gold nanoparticles.

Why? Because gold nanoparticles have been proven to convert light into heat highly efficiently at localized regions.

The technique of using gold nanoparticles in light-heat conversion processes had already been tested in cancer treatments in previous studies.

Knowing that more than 20 million hernia repair operations take place every year around the world, the researchers believed this method could reduce the medical costs in recurrent operations while eliminating the expensive and ineffective antibiotic treatments that are currently being employed to tackle this problem.

Schematic view of plasmon-enabled biofilm prevention on surgical meshes. Credit: ICFO

Thus, in their in-vitro experiment and through a thorough process, the team coated the surgical mesh with millions of , uniformly spreading them over the entire structure. They tested the meshes to ensure the long-term stability of the particles, the non-degradation of the material, and the non-detachment or release of nanoparticles into the surrounding environment (flask). They were able to observe a homogenous distribution of the nanoparticles over the structure using a scanning electron microscope.

Once the modified mesh was ready, the team exposed it to S. aureus bacteria for 24 hours until they observed the formation of a biofilm on the surface. Subsequently, they began exposing the mesh to short, intense pulses of near  (800 nm) over 30 seconds to ensure  was reached, before repeating this treatment 20 times with four seconds of rest intervals between each pulse.

They discovered the following: First, they saw that illuminating the mesh at the specific frequency would induce localized surface plasmon resonances in the nanoparticles—a mode that results in the efficient conversion of light into heat, burning the bacteria at the surface.

Second, by using a fluorescence confocal microscope, they observed how much of the bacteria had died or was still alive. They observed that the remaining living biofilm bacteria became planktonic cells, recovering their sensitivity or weakness toward antibiotic therapy and to immune system response. They observed that upon increasing the amount of light delivered to the surface of the mesh, the dead bacteria would lose their adherence and peel off the surface. 

Third, they confirmed that operating at near infrared light ranges was completely compatible with in-vivo settings, meaning that such a technique would most probably not damage the surrounding healthy tissue. Finally, they repeated the treatment and confirmed that the recurrent heating of the mesh had not affected its conversion efficiency capabilities.

ICREA Prof at ICFO Romain Quidant says, “The results of this study have paved the way towards using plasmon nanotechnologies to prevent the formation of bacterial biofilm at the surface of surgical implants. There are still several issues that need to be addressed but it is important to emphasize that such a technique will indeed signify a radical change in operation procedures and further patient post recovery.”

Director of Research and Development of B. Braun Surgical, S.A. Dr. Pau Turon, says, “Our commitment to help healthcare professionals to avoid hospital related infections pushes us to develop new strategies to fight bacteria and biofilms. Additionally, the research team is exploring to extend such technology to other sectors where biofilms must be avoided.”

More information: Ignacio de Miguel et al, Plasmon-Based Biofilm Inhibition on Surgical Implants, Nano Letters(2019).  DOI: 10.1021/acs.nanolett.9b00187

Journal information: Nano Letters , Nature Photonics

Provided by ICFO

Advertisements

Please leave us your comments and any suggestions. Thanks! Administrator at GNT

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s